May 01, 2026 Leave a message

Introduction to milling machine blades

Milling machine inserts are industrial cutting components mounted on milling machines, primarily used for road surface treatment, including removing cement laitance, roughening, and repairing asphalt pavements.

 

Small milling machine inserts are embedded carbide inserts, typically made of tungsten carbide alloy. The insert head shapes include cylindrical, pointed, and square.

The inner bore diameter of the insert is determined by the milling machine's cutter shaft diameter. The insert bore diameter is generally 4-6mm larger than the cutter shaft diameter to ensure a certain clearance after installation.

 

Round inserts are mainly used for milling concrete floors and cement/asphalt pavements, achieving a deeper milling depth and producing a rough surface. Square inserts are mainly used for milling away road markings and hot-melt painted surfaces, achieving a shallower milling depth and producing a smooth surface.

 

To maintain the milling machine's working efficiency and extend the life of the inserts, proper maintenance is essential. Inserts should be replaced promptly when they show more than 1/2 wear or other severe wear. When replacing inserts, ensure the inserts extend at the same length; it is recommended to replace them as a set. Properly controlling the amount of cooling water in the cutter head (for example, reducing the amount of water sprayed when the milling depth is less than 6cm) can prevent thermal erosion of the carbide cutter head. During continuous operation, the machine should be stopped every 6-8 hours to check the cutter rotation and wear.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry